Union of http://terminology.hl7.org/CodeSystem/v2-0206 and http://terminology.hl7.org/CodeSystem/v2-0206

This is the CodeSystem that contains all the codes in segmentAction (http://terminology.hl7.org/CodeSystem/v2-0206) and segmentAction (http://terminology.hl7.org/CodeSystem/v2-0206). E.g. what you have to deal with if you get resources containing codes in either of them

CodeSystem

Generated Narrative: CodeSystem 2c77c26f-0eba-4543-89eb-09eda3cba01c-1964

Properties

This code system defines the following properties for its concepts

NameCodeURITypeDescription
statusstatushttp://terminology.hl7.org/CodeSystem/utg-concept-properties#statuscodeStatus of the concept
deprecateddeprecatedhttp://terminology.hl7.org/CodeSystem/utg-concept-properties#v2-table-deprecatedcodeVersion of HL7 in which the code was deprecated
V2 Concept Commentv2-concCommenthttp://terminology.hl7.org/CodeSystem/utg-concept-properties#v2-concCommentstringV2 Concept Comment
statusstatushttp://terminology.hl7.org/CodeSystem/utg-concept-properties#statuscodeStatus of the concept
deprecateddeprecatedhttp://terminology.hl7.org/CodeSystem/utg-concept-properties#v2-table-deprecatedcodeVersion of HL7 in which the code was deprecated
V2 Concept Commentv2-concCommenthttp://terminology.hl7.org/CodeSystem/utg-concept-properties#v2-concCommentstringV2 Concept Comment

Concepts

This code system http://hl7.org/fhir/comparison/CodeSystem/2c77c26f-0eba-4543-89eb-09eda3cba01c-1964 defines codes, but no codes are represented here

CodeDisplayDefinitionV2 Concept CommentV2 Concept CommentDeutsch (German, de)
A Add/InsertAdd/InsertEinfügen
D DeleteDeleteLöschen/Stornieren
S Used in Snapshot modeDeclares when segment falls under snapshot mode handling, i.e. all elements that were previously sent will be sent, not just any changesSnapshot mode is the expected default; use this code to explicitly state that., Snapshot mode is the expected default; use this code to explicitly state that.Snapshot mode is the expected default; use this code to explicitly state that., Snapshot mode is the expected default; use this code to explicitly state that.
U UpdateUpdateÄndern
X No ChangeNo Change